Fan - HP Envy 17 Maintenance And Service Manual

3. Pull the drive away from the socket to remove it (2).
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.

Fan

To remove the fan, use this procedure and illustration.
Table 5-8 Fan description and part number
Description
Fan assembly
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the fan assembly:
1. Disconnect the fan cable from the system board (1).
2. Remove the three Phillips M2.0 × 3.5 screws from the left fan (2) and remove the three Phillips M2.0 ×
3.5 screws from the right fan (3).
(Preparation for disassembly on page
(Bottom cover and rubber feet on page
Battery on page 32).
Spare part number
xxxxxx-001
31).
31).
Component replacement procedures 41