Jonsered 6000+ Operator's Manual page 29

13. Release the log and rotate it through 90°.
14. Adjust the position of the short end of the log
using the log lifter and secure the log, locking
it in position with the flat surface hard up
against the stop.
15. Saw off the upper slab. See pages 9-10.
16. Release the log, rotate it through 180°, lower
the height adjusting device and lock the log
in position.
17. Saw the timber block into boards according
to the instructions above. Remember to
compensate for the thickness of the saw
blade every time you reset the the saw-blade
height.
Particulars of the height adjustment crank:
• 1 full turn = 5 mm
• The pitch disc can be reset by turning it.
Trimming the edges
The edges of several boards can be trimmed at
the same time by securing them hard up against
the stop.
To ensure that the boards will remain stationary
while they are being sawed, place one board
upright between the boards to be trimmed and
the stop. This board should be at least 50 x 100
mm.
GENERAL USE
29
English