Canon Selphy Square QX10 Getting Started page 15

Paper is not ejected from the delivery outlet.
• If the paper extends partially from the front of the printer, pull out the
paper. However, if the paper cannot be pulled out by lightly gripping it
with your fi ngers, do not pull excessively on the paper. In this case, turn
the power off and then on again repeatedly until the paper is ejected.
If you accidentally turn off the power during printing, turn on the power
again and wait until the paper is ejected.
• If the paper has jammed, contact a Customer Support Help Desk. Do
not attempt to remove the jammed paper by force. This may cause
malfunction.
Wi-Fi
The message "The printer cannot be found." is displayed.
• Check that the power is turned on. (= 7)
• Turn on location services on the smartphone.
• To newly register the printer to the app, tap
of the app home screen and then tap "Do you want to use another
QX10? >".
• Registration using the QR code will not be possible if the password has
been changed using "Change the password". In this case, register the
printer manually.
• If you forgot the password, do the following to initialize the printer settings
and then register the printer to the app again.
Turn on the power. → Press and hold the Power button. After 1 second,
the STATUS lamp turns off . → Continue pressing the Power button. →
When the STATUS lamp begins to blink, release the Power button.
Printing takes time.
• Do not use the printer near a microwave oven or equipment (Bluetooth,
etc.) that uses frequencies in the 2.4 GHz band. This may degrade the
Wi-Fi signal environment.
• Place the printer and smartphone close to each other without any objects
between them.
in the upper left corner
15