[System] > [Video And Audio] > [Audio]; General Audio - Canon CR-N500 Settings Manual

[System] > [Video and Audio] > [Audio]
Settings for the audio input from the microphone connected to the camera and for the bit rate for IP audio streaming.

General Audio

Settings for the volume of the audio input and the type of microphone.
[Audio Input]
Select whether to use audio from the microphone.
When [Disable] is selected, Audio cannot be outputted from HDMI/SDI output.
Note
To set [Audio Input] to [Disable], all of the following settings must be changed to [Disable].
– [System] > [Server] > [RTP Server] > Each stream (Main, Sub1, Sub2) > [Audio Transmission]
– [System] > [Communication] > [External Connection (IP)] > [NDI|HX] > [Audio Transmission]
– [System] > [Communication] > [External Connection (IP)] > [RTMP] > [Audio Stream]
[Audio Input Mode]
Select the type of microphone to connect to the camera: input terminals (INPUT/MIC), input method (LINE/MIC), and with or
without power to the microphone.
Setting Value
MIC Terminal/LINE
MIC Terminal/MIC
MIC Terminal/MIC (MIC Power On)
INPUT Terminal/LINE
INPUT Terminal/MIC
INPUT Terminal/MIC+48V
Note
To use a microphone that requires phantom powering, turn it on while connected, and then set it to [INPUT Terminal/MIC+48V].
When using a microphone, set [Audio Input Mode] correctly according to the specifications of the microphone.
Failure to do so may damage the camera or microphone.
[Input Volume]
Settings for the volume to be inputted from the microphone connected to the camera.
[Current Volume Level (L)], [Current Volume Level (R)]
Displays the current volume level in the status bar.
Input Terminal
MIC
MIC
MIC
INPUT
INPUT
INPUT
Caution
47
Input Method Power to Microphone
LINE
MIC
MIC
LINE
MIC
MIC
-
Not Supported
Supported
-
Not Supported
+48V