Page 1
Boat Shaped Conference Table • SCTBS7135, SCTBS9543 • INSTRUCTIONS Organize your parts. You may need a rubber mallet. Parts : B: Modesty A: Tabletop Quantity: 1 Quantity: 2 D: Cantilever F: Flat Bracket C: Legs Quantity: 2 Quantity: 2 E: Center Support...
Page 2
Boat Shaped Conference Table • SCTBS7135, SCTBS9543 • INSTRUCTIONS Organize your parts. You may need a rubber mallet. STEP 1 : Attach Modesty (B) to Leg (C) by inserting E-Clips into grooves and sliding down into place (See Figures 1 and 2). Please note there are (2) grooves on the inside of Legs (C) and only one on the outside.
Page 3
Boat Shaped Conference Table • SCTBS7135, SCTBS9543 • INSTRUCTIONS Organize your parts. You may need a rubber mallet. STEP 4 : Attach Center Support (E) to Modesty (B) by inserting Lockdowels into coordinating holes and pressing down into place (See Figure 3).