Related Manuals for National Instruments SCXI-1382
Summary of Contents for National Instruments SCXI-1382
- Page 1 (217) 352-9330 | Click HERE Find the National Instruments SCXI-1382 at our website:...
- Page 2 April 2003 company names mentioned herein are trademarks or trade names of their respective companies. For patents covering 371189A-01 National Instruments products, refer to the appropriate location: Help»Patents in your software, the patents.txt file on your CD, or ni.com/patents. ni.com...
-
Page 3: What You Need To Get Started
Recommended, sold separately with country appropriate power cord options – SCXI-1383 power supply/float charger Before using the SCXI-1382 battery pack for the first time, charge it for at least 24 hours to reach the full charge capacity. Note Refer to the Charging the Battery Pack section for charging instructions. -
Page 4: Charging The Battery Pack
Charging the Battery Pack The SCXI-1382 battery pack requires 12 to 14 VDC and at least 3.7 A of power for at least 12 to 14 hours to reach a full charge. Charge the battery pack as soon as possible after use. If the battery is fully charged, it can power the SCXI-1000DC chassis for more than five hours. - Page 5 SCXI-1000DC chassis. Caution The SCXI-1382 battery pack connector, J2, is an input-only connector for the SCXI-1383 power supply/float charger. Do not connect the SCXI chassis to this connector. Power on the SCXI-1000DC chassis using the power switch on the front panel of the chassis.
- Page 6 2 8-32 x 7/16 in. Screws 5 SCXI-1382 Battery Pack 8 6-32 x 1/4 in. Screw 3 Mounting Bracket 6 F3 9 J1 Figure 1. Connecting the SCXI-1382 to the SCXI-1000DC Chassis © National Instruments Corporation SCXI-1382 Battery Pack Installation Guide...
- Page 7 50/60 Hz power source. Switch on the AC power source. The SCXI-1383 power supply/float charger is now powered up and is float-charging the SCXI-1382 battery pack. Power on the SCXI-1000DC chassis using the power switch on the front panel. While in float-charging mode, the green LED on the top of the SCXI-1383 case Note illuminates only if the battery is not fully charged.
-
Page 8: Specifications
7 P2 3 J2 Charger 8 P1 Figure 2. Connecting the SCXI-1382 in the Float-Charging Mode to the SCXI-1000DC Chassis and the SCXI-1383 Power Supply/Float Charger Specifications All specifications are typical at 25 °C unless otherwise specified. Refer to the SCXI-1383 Power Supply/Float Charger Installation Guide for its Note specifications. -
Page 9: Electromagnetic Compatibility
Maximum altitude....2,000 meters Pollution Degree ...... 2 (indoor use only) Safety The SCXI-1382 is designed to meet the requirements of the following standards of safety for electrical equipment for measurement, control and laboratory use: • IEC 61010-1, EN 61010-1 •... - Page 10 CE Compliance The SCXI-1382 meets the essential requirements of applicable European Directives, as amended for CE marking, as follows: Low-Voltage Directive ....73/23/EEC (safety) Electromagnetic .......89/336/EEC Compatibility Directive (EMC) Refer to the Declaration of Conformity (DoC) for this product for any additional Note regulatory compliance information.