Summary of Contents for National Instruments NI HDD-8265
Page 1
INSTALLATION GUIDE NI HDD-8265 Battery Pack Accessory This guide explains how to install the NI HDD-8265 Battery Pack Accessory. Complete the following steps to install the battery pack accessory: Remove the NI HDD-8265 chassis cover by unscrewing the rear thumbscrew and two side screws (one on each side of the chassis), as shown in Figures 1 and 2, and sliding the cover toward the rear of the chassis.
Page 2
Insert one end of the ribbon cable included with the battery pack accessory kit into the 12-pin connector labeled J1 on the battery pack card, as shown in Figure 4. Figure 4. Inserting the Ribbon Cable into the Battery Pack Accessory NI HDD-8265 Battery Pack Accessory Installation Guide ni.com...
Page 4
For patents covering National Instruments products/technology, refer to the appropriate location: Help»Patents in your software, the patents.txt file on your media, or the National Instruments Patent Notice at ni.com/patents.