Advertisement
4. Conductors Connection
Connection to Inputs of RPCM DC ATS 76А
Carefully study the labeling and polarity
of the connection.
Remove the insulation from the wire.
When using flexible wires without
ferrule, you must first open the spring.
To do this, insert a screwdriver into the
rectangular shaft near the clamp.
Note. To disconnect, you must also
insert a screwdriver into the
rectangular shaft next to the clip.
IMPORTANT! No mechanical loads should be transferred to the Push-in spring clip, otherwise
the electrical connection may be damaged.
For this, the cable may, for example, be secured in front of the push-in clamp using a cable clip.
Conductors Connection to Outlets of RPCM DC ATS 76А and RPCM DC 232А
To connect the conductors to the terminals, use the terminals in
the form of a push-in clamp.
To connect the conductor to the
RPCM DC ATS 76A or RPCM DC
232A terminal, you must:
Remove the insulation from the
conductor.
Insert the conductor directly into the
round hole of the terminal.
To open the spring, press the orange
Push button with a screwdriver.
Similarly connect the second
conductor.
Note. To remove the conductor, you
also need to push in the orange Push
button with a screwdriver.
Fig. 6. Connecting wires to the inputs RPCM DC ATS 76A
Fig. 7. Connect the conductor to the RPCM DC ATS 76A
or RPCM DC 232A outlet terminal
4
Advertisement
