Advertisement
Quick Links
Advertisement
Related Manuals for Phil&Teds e3
Summary of Contents for Phil&Teds e3
- Page 1 ™ your e3 survival guide...
- Page 2 evolution is watching a baby develop. revolution is watching the buggy develop, from newborn to upright toddler(s)
- Page 3 nitty gritty nitty gritty bits bobs one: wheeling dealing two: swivel swerve three: running four: handling five: hooding up six: insert baby downs newborn toddler welcome to the ones twos adaptable delightful baby toddler world of double our boxes make a great tricks treats distraction for your children while...
- Page 4 (see page 10) This is often purchased with your e3 buggy; carton should contain the following Open your e3 carton and check that the bits and bobs following bits and bobs are there 2 x rear wheels...
- Page 5 one: wheeling dealing Take main buggy and lay flat (sunhood Hold silver button in while inserting down) as shown. wheel axle into buggy frame. Line up silver button so it pops out of hole on frame. Remove rear wheels from plastic bag (discard bag immediately –...
- Page 6 two: swivel swerve Lift footwell as far as hinge will allow. Remove front wheel from bag (the rod is greased so watch out for greasy fingers!). to lock the front wheel Align silver button with small hole on inside of front wheel black cap. Turn wheel towards rear wheels Extend black of buggy so front wheel is directly...
- Page 9 five: hooding up six: insert baby Pull up seat fabric and attach to Apply brakes and insert baby using safety lower snaps on handle – both left harness. (Ted stood in for baby!) and right side. Unclip 4 buckles on breastplate Attach snaps on back of sunhood to (circled in red) and place baby higher snaps on handle, both left and...
- Page 10 downs newborn buggy Undo zips fully (carry a newborn baby) on either side of seat base for a With buggy set up ready to go, completely flat apply brakes. newborn bed. Undo 2 clips at back of seat, and ‘b’. ‘a’...
- Page 11 downs Attach clips at top of seat base to back toddler buggy of seat fabric. (carry a child) This position is generally comfortable for a recline seat child from 3-6 months, once child is strong enough to support its head. Unzip zips inside seat to recline.
- Page 12 ones twos Setting up the baby ` toddler buggy: baby ` toddler buggy (carry a newborn baby & child) Ensure that buggy is in newborn position. Put brakes on. To use position requires baby ` toddler purchase of double kit accessory. Remove bumper bar from front of buggy by pressing silver buttons in on Double seat height can be adjusted by...
- Page 13 ones twos Double seat will sit on main frame of buggy. ensuring buttons pop through holes on frame. To attach retaining strap on double seat: Undo snaps at top of sunhood. Push sunhood forward. Attach retaining strap at back of double seat around main buggy frame using clip.
-
Page 14: Buggy Covers
tricks treats buggy covers stormy weather & uv sunny days double stormy weather & uv sunny days Unfold cover carefully. Unfold cover. Place over sunhood. Attach around handle using snaps on each side of cover. Place over sunhood and attach using the snaps around handle and snaps Attach cover to lower frame using at footwell. -
Page 15: Buggy Cocoon
The cocoon is a light, portable carry-cot The pollution solution buggy cover is made which fits quickly and easily in buggy, so from a special mesh that protects baby you can move a sleeping child to and from from the fine microns &... -
Page 16: Buggy Storage
Can also be used on buggy side (right hand side when around waist - adjust standing at back of buggy). for comfort on hips. e3 travel bag Remove buggy wheels (and rear guards) to fit buggy into bag. Can fit buggy and... -
Page 17: Buggy Liners
tricks treats buggy liners buggy bunny race seat Place in buggy and Feed harness feed harness straps shoulder straps through gaps. through D rings at top of race seat. woolly & warm Feed harness straps through slots on rear sponge ted of liner (cut new slots as required). - Page 18 ™ ™ smartbuggy ™ metoo ™ metro adapt survive! ™ ™ escape tott...
- Page 19 Standard tyre kits can repair punctures. A flat tyre can result from grit e3’s coat holding the valve open; to check: inflate tyre, The fabric is backed with a water-resistant deflate rapidly, and re-inflate. Tyres and tubes coating.
- Page 20 rights remedies Normal wear, fading and fabric cuts. our warranty and service policy Improper use (by way of example): abnormal We want to give owners confidence in the use; not following instructions; child left quality of our products. They are warranted unattended;...
- Page 21 return relax ™ warranty form Name Which most excellent product did you buy? twin escape Address smartbuggy metro accessories metoo bebe double kit pepe tott Date of purchase? Phone Rate from 1-10 how likely you would be to Email recommend this product to someone else? Just a few extra details to help us adapt survive!
- Page 22 affix stamp here ™ 102-112 daniell street newtown wellington 6002 new zealand...
- Page 23 warnings ! WARNING: Apply brakes when you park Keep with your buggy for future reference. the buggy. Apply brakes when loading or Injury may result if you do not follow all unloading children. WARNING: safety precautions. Injury may result from Buggy in single or baby improper use.
- Page 24 New Zealand Limited is the owner of all past, present and future intellectual property used and developed in relation to the business and reserves all rights in relation to its intellectual property and the presentation of it. © phil & teds most excellent buggy company ltd Issue 1 (e3) April 2006...
Need help?
Do you have a question about the e3 and is the answer not in the manual?
Questions and answers