Advertisement

Folding
without double kit attached,
or with the double kit on front of the
buggy in toddler/newborn position.
Note
The double kit must be attached to
the top set of holes if you wish to leave it
on while folding the buggy, see image b.
Note
If you would like to tow the buggy
like a trolley once folded, leave the brake
off and the bumper bar attached. (Super
useful in airports and the like!)
a
Rotate the multi-adjust
handle into the highest
position.
b
Open both of the black hinge locks.
(Those paddle things on either
side of the frame).
Top holes.
vibe folding instructions
Please read ALL the instructions and look CAREFULLY at the pictures. Trust us; this will really help!!!
c
Make sure the front wheel is in swivel
mode and the child harness is undone.
d
Push the main seat base
(fabric seat) upward until it's
fully inverted.
e
Ensuring that the parcel tray is folded
upwards at the centre, depress the red
safety latch and fold
the frame together.
model GT issue April 2008
Push the seat
fabric up from
underneath.
Here it is.
Jbar.
Note
When fully folded the front wheel
should rest on the buggy handle with the
Jbar facing outwards. (The Jbar is the black
plastic bit, shaped like an upside down 'J',
connected to the front wheel axle).
f
Lay the buggy on the ground with the
handle facing upwards and close both
of the black hinge locks, (those same
paddle things).
done!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Phil&Teds GT

  • Page 1 GT issue April 2008 Please read ALL the instructions and look CAREFULLY at the pictures. Trust us; this will really help!!! Folding Make sure the front wheel is in swivel without double kit attached, mode and the child harness is undone.
  • Page 2 Folding with the double kit in rear Open the double kit nib springs, allowing Ensuring that the parcel tray is folded position the double kit to pivot on the cross bar. upwards at the centre, depress the red safety latch and fold the frame together. Note If you would like to tow the buggy These things are...
  • Page 3 Unfolding Unfolding without double kit attached, with the double kit in Close both of the black hinge locks. or with the double kit on front of the buggy in rear position. (Those paddle things on either toddler/newborn position. side of the frame). Repeat unfolding instructions a-c.
  • Page 4 GT issue April 2008 Please read ALL the instructions and look CAREFULLY at the pictures. Trust us; this will really help!!! To attach Open the sunhood into desired The hood attaches to the buggy position. frame using the two clips (on either side of the hood).

Table of Contents