Using Online Help - Alesis Wedge Reference Manual

Chapter 1 – Your First Session with the Wedge
To edit effect parameters:
Ê Press the [PAGE] button to enter Edit mode.
This selects the first page of effect parameters, if you are editing the Program for the first
time. There are usually two or more pages available in Edit mode, depending on the
Program's Configuration. The exact number of pages available will be indicated by the
numbers illuminated in the bottom-left corner of the display. Repeatedly pressing
[PAGE] cycles through the available pages. The currently selected page will have a box
around its number. Each page contains up to four parameters, which are labeled with
abbreviated names directly above each.
Ë Move one of the [A-D] sliders.
The parameter will flash indicating it is selected for editing. Once you have modified a
parameter's value, the word "EDITED" will appear directly beneath it. If you change the
value back to its original setting, the word "EDITED" will disappear.
J
Any changes you make are temporary, until you store those changes into memory. If the
Program you are editing is in the Preset bank, you must save the changes you've made to a
location in the User bank. If you recall another Program before storing, your changes will be
lost. For more information , see "Storing Edited Programs", later in this chapter. For more
about editing effects parameters, see Chapter 4.

Using Online Help

The Wedge has built-in online help to assist you in identifying parameter functions
from the display, without having to look things up in this manual. Once you have
accessed Edit mode (see previous section), you can select any of the parameters
shown in the display by pressing the corresponding button ([A], [B], [C] or [D]).
However, by holding one of these buttons for more than one second, the upper
display will provide a more detailed description of the selected parameter.
For example, if we were still editing Preset 18 (see previous page), holding the [D]
button for more then one second would reveal the name of the "D" parameter:
INPUT LOWPASS FILTER
Once the button is released, the display reverts back to normal.
12 Wedge Reference Manual