Misc - Alesis S4 Plus Reference Manual

the mod wheel as the Source, the mod wheel could be programmed to cause the
Reverb to increase the decay (positive) or decrease the decay (negative).
Mix
Not to be confused with an actual Mix or Mix mode, the Effect's Mix function is where
you can mix the various signal levels of all the effects to the Main Left and Right
outputs of the S4 Plus. Only effect modules that have access to the Main outputs will
appear on the Mix page. There is a separate Mix page for each of the four effect
busses whose effect modules feed the main output. Note that the Mix page doesn't
control how much the individual effect modules feed to each other; only how much
they feed to the Main outputs.
MIDI
1
CHAN
EDITING:
PITCH
CONFIG
PAGE: 1
Depending on the selected Configuration, the order of the effects will differ (for
example: in Configuration #1, the order reads Pitch, Delay, Reverb; but in
Configuration #2, the order is Delay, Pitch, Reverb).
Pitch Level
Adjusting this value will cause the Pitch Output Level to increase or decrease. The
Pitch Output level is the level for the Pitch Section of the S4 Plus's effects processor
to the Main outputs, and should be set as desired. Even if this parameter is set to 00,
the output of the Pitch section is still available (depending on the bus and
configuration) to following Delay and Reverb sections.
Delay Level
Adjusting this value will cause the Delay Output Level to increase or decrease. The
Delay Output level is the level for the Delay Section of the S4 Plus's effects processor
to the Main outputs, and should be set as desired. Even if this parameter is set to 00,
the output of the Delay section is still available (depending on the bus and
configuration) to following Pitch and Reverb sections.
Reverb Level
Adjusting this value will cause the Reverb Output Level to increase or decrease. The
Reverb Output level is the level for the Reverb Section of the S4 Plus's effects
processor to the main outputs, and should be set as desired.

Misc.

This Misc. Function is only available when using Configuration #s 4 or 5. In
Configuration 4, the Misc. Function is where the EQ parameters are found. In
Configuration #5, the Misc. function houses both the Overdrive parameters and the
EQ parameters (the EQ is found on Page 3). In all cases, the Misc. Function can be
selected and its parameters edited regardless of which Effects Send (1–4) is
selected.
S4 Plus Reference Manual
PROG
PRESET
1
MOD
REVERB DELAY MIX MISC.
Editing Effects: Chapter 7
EFFECT
107