Trouble-Shooting Index; Re-Initializing; Checking Software Version - Alesis QS6 Reference Manual

To send the entire User bank via MIDI:
¿
Connect a MIDI cable from the QS6's MIDI Out to the MIDI In of a device capable
of receiving the data (a MIDI sequencer, another QS6, etc.).
¡
Press [STORE].
¬
Press [PAGE
The display will look like this:
÷
Press [STORE] to transmit the data out the MIDI Out connector.
While transmitting the data, the display will temporarily read " SENDING OUT
MIDI DATA..... ".
To send a single Program via MIDI:
¿
Follow steps
¡
Press [PAGE
The display will look like this:
¬
Use the [CONTROLLER A] slider to select a Program to transmit. You may select
any Program in the User bank (000 to 127) or the Program Edit buffer (EDIT) or
any of the 16 Mix Edit buffers (Em01 to Em16).
As this value is changed, the second parameter (destination) will be linked. This
is because most often you will want to transmit a Program to the same Program
location. The only time to do otherwise is when sending to another QS6 (see
below).
÷
Press [STORE] to transmit the data out the MIDI Out connector.
To send a single Program via MIDI to a different Program number:
¿
Follow steps
¡
Press [PAGE
¬
Use the [CONTROLLER A] slider to select a Program number to send the
Program to.
÷
Press [STORE] to transmit the data out the MIDI Out connector.
The procedure is similar for sending Mixes. Page 5 of the Store function allows you to
send any one of the Mixes. In the case of storing a Mix, you may want to store each
of the Programs used in the Mix. The "SEND ALL TO MIDI" command in Store mode
is an easy shortcut to this (see above).
QS6 Reference Manual
MIDI Transfer and Storage Operations: Chapter 9
]four times to select Page 3 of the Store function.
SEND ALL DATA
TO MIDI? (STORE)
¿ ¡
and in the instructions above.
]five times to select Page 4 of the Store function.
MIDI PRG 000 TO
PRG 000? (STORE)
¿ ¬
through in the instructions above.
] to advance the cursor to the lower section of the display.
123