Download Print this page
JBL EON515 Technical Manual
Hide thumbs Also See for EON515:

Advertisement

Quick Links

Technical Manual
JBL EON515/230
SPECIFICATIONS
ACOUSTIC & ELECTRICAL SPECIFICATIONS:
• System Power Rating:
• Frequency Response:
• Frequency Range:
• LF Power Amp:
• HF Power Amp:
• Input Gain (input 3):
• Input Gain (input 1 & 2):
• Input Impedance:
• Boost EQ:
• Low Cut Filter:
• Crossover Frequency:
SYSTEM COMPONENTS:
• Cabinet:
• Baffle/Grille Assembly:
• Low Frequency
Transducer:
PACKAGE
JBL Incorporated, 8500 Balboa Boulevard, P.O. Box 2200, Northridge, California 91329 U.S.A.
450 W continuous, 900 W peak
42 Hz – 18 kHz (± 3 dB) (EQ in "Flat"
position)
39 Hz – 20kHz (-10 dB) (EQ in "Flat"
position)
350 W continuous at driver impedance
100 W continuous at driver inpedance
Mic position: -Infinity to +40 dB
Line position: -Infinity to +4 dB (+20
dBu Max signal input)
-Infinity to +4 dB (+20) dBu Max signal
input)
64 K ohms (balanced) 32 K (unbal-
anced)
LF +3 dB Shelfing Filter @ 200 Hz
HF + 25 dB Shelfing Filter @ 4 kHz
Preset high pass @ 120 Hz
2.2 kHz
(Not for Sale)
441739-001
265F-1 380 mm (15 in) Different-
®
ial Drive
integated woofer with dual
2" voice coils
Warranty 59660
Owners Manual
364822-001
(Available on web-site
only)
Fillers (2)
364823-001
Bag
322591-001
19"x16"xc42" LG
.003 THKLDPE
CLEAR
Carton
364824-001
Cord, AC, Line
425-00000-00 120V
425-00000-01 230V
SYSTEM COMPONENTS: (CONT'D)
• DC Resistance:
• High Frequency
Transducer:
• DC Resistance:
• Input 3 connector:
• Input 1 & 2 connectors:
• Output (Loop/Mix switch):
• XLR Pin Assignments:
AURAL SWEEP TEST SPECIFICATIONS:
A. System Aural Sweep Test: 1.0Vrms Input, 20 Hz to 2 kHz
B. L.F. Aural Sweep Test:
C. H.F. Aural Sweep Test:
PHYSICAL SPECIFICATIONS:
• Enclosure Dimensions:
• Shipping Weight:
WARRANTY INFORMATION:
• Refer to Warranty Statement packed with each product.
WIRING DIAGRAM
Driver, High Freq
2414H
(342423-002X)
- +
GRN
GRN / BLK
(SEE SCHEMATIC PAGE)
1.35 ohm ±10%
2414H 25.4 mm (1 in ) neodymium
compression driver
3.60 ohm ± 0.2%
Balanced XLR / 1/4 inch TRS combo
jack with XLR loop through
Balanced 1/4 inch TRS jack
Balanced male XLR, +20 dBu (peak)
o/p level in MIX position
Pin 2 (+), Pin 3 (-), Pin 1 (GRN)
Ch 1 input all and pots full clockwise
3.5V Input,10 Hz to 300 Hz
.75V Input, 500 Hz to 1.5 kHz
685 x 435 x 366 mm D
(27.0 x 17.3 x 14.4 in D)
32.5 lbs. (14.8 kg)
Driver, Low Freq.
265F-1
(363837-001X)
Cone Repl
C2R265-1
-
+
BLU
BLU/BLK
Amplifier Assembly
364675-001
Wire Harness
364836-001
04-09

Advertisement

loading

Summary of Contents for JBL EON515

  • Page 1 JBL Incorporated, 8500 Balboa Boulevard, P.O. Box 2200, Northridge, California 91329 U.S.A. Technical Manual JBL EON515/230 SPECIFICATIONS ACOUSTIC & ELECTRICAL SPECIFICATIONS: SYSTEM COMPONENTS: (CONT’D) • System Power Rating: 450 W continuous, 900 W peak • DC Resistance: 1.35 ohm ±10% •...
  • Page 2 JBL EON515/230 SCHEMATIC ( Wire Harness) 364836-001...
  • Page 3 Silipad, EON 500 RND, PH, CLR, (363837-001X) 140325-1JBL Rubber Foot (2) Nut (4) ZINC LCS Cone Repl 364802-001 838-00800-00 C2R265-1 Silipad, EON515 IGBT M14,REG,CLR ZINC,RH 138526-1JBL Screw (8) 365626-001 Washer (4) Silipad, MRX M5 PTx25MM 848-00100-02 138525-1JBL FIL,PH,BLK,ZINC, M14,REG, CLR ZINC...

This manual is also suitable for:

Eon230