Advertisement
Quick Links
Advertisement
Related Manuals for FLYSURFER SPEED5 FDS-KIT
Summary of Contents for FLYSURFER SPEED5 FDS-KIT
- Page 1 FDS-KIT SPEED5 How to install the Full Depower Safety...
-
Page 2: Attachment Points
By default, the SPEED5 is equipped with a frontline safety (FLS). The FDS-System enables you to fly your SPEED5 ATTENTION! Each FDS-Kit is made with an additional 5th line. In an emergency situation, just for a specific kite size. Never use this activate your Quick Release. - Page 3 1. Disconnect the big steel ring from the FLS-endline. Pull the FLS-endline through the Quick Release, Bar Eyelet and Guidance Block or steel ring(s). Next disconnect the Safety-endline from the Frontline.
- Page 4 2. Loop the five pink LCL around the attachment points. Take the white FDS-toplines named FDS-A, FDS-B, FDS-C, FDS-D and FDS-BR and connect them to the corresponding pink LCL with a larks head knot.
- Page 5 Pull end of line Remove Make a figure Connect the through QR stopper knot of eight knot FDS-flyingline 3. Loop the FDS-extension through the end of all five FDS-toplines. Make sure that the FDS-toplines are lined up one after the other. Finally thighten this connection. SAFETY-ENDLINE spliced part Elastic part...
- Page 6 5. Connect the red FDS-flyingline with the Safety-endline and the small steel ring as shown in pictures below. Pull the red line through the loop on the Safety-endline and tighten the connection. Elastic part 6. Disconnect the right frontline, pull it through the 7.
- Page 7 8. Push the end of the Safety-endline through the steel ring(s) (NOT Guidance Block), Bar Eyelet, and Quick Release. Finally, reconnect the end of the line to the steel ring using a larks head knot.
- Page 8 Release and that the safety-system is free of tension while flying the kite. FLYSURFER Kiteboarding Brand of Skywalk GmbH & Co. KG Windeckstr. 4 83250 Marquartstein, GERMANY flysurferkiteboarding | www.flysurfer.com | info@flysurfer.com | +49 (0) 86 41 69 48 - 30...