Table of Contents
Advertisement
Recon Wireless Blockage and Flow Monitor (WBFM) Troubleshooting Guide
What should the TP-Link LEDs look like?
The power light and the 4 signal lights should be green during normal operation.
If only the power light is on the TP Link has lost its configuration. Refer to the instructions in
WBFM Access Point Configuration Service Bulletin to configure your TP Link:
www.intelligentag.com/wp-content/uploads/2019/09/600870-000028-WBFM-Access-Point-
Configuration-Service-Bulletin_rev-1.1.pdf
The LAN light should only be on during the reconfiguration process while it is connected to a
computer.
600820-000012, rev 2.1
Page 10 of 31
Advertisement
Table of Contents
Need help?
Do you have a question about the RECON and is the answer not in the manual?