Operating Controls; Start-Up; Assembly - MTD L 17 Original Operating Instructions

Operating controls

Operating controls
Control elements R
1 Power pack
2 U-shaped grip
3 Top suction/blow pipe
4 Fastening hook
5 Bottom suction/blow pipe
6 Intake opening
7 Blow opening
8 Transport wheel
9 Turbine wheel cover fixing screw
10 Turbine wheel cover
11 Carrying belt
12 Handle
13 On/off switch
14 Rotary switch with motor speed function
15 Quick-release lever for U-shaped grip
16 Release mechanism for leaf bag
17 Vacuum/blow selection lever
18 Vacuum bag with zip
Supplementary documentation
Make sure the operating manuals of the
40V FAST CHARGER and the 40V LI-ION
power pack are available. Please read
and understand them before putting the
device into use.
Power pack charging
Risk of injuries or material damage
¾ Only charge the power pack with the 40V
FAST CHARGER.
Attention!
The power pack is supplied partially charged.
Before first use, fully charge the power pack
using the 40 V FAST CHARGER to ensure the full
capacity of the power pack.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.

Start-up

WARNING!

Assembly

Risk of injuries
ÂWhen using the tool, incorrectly fitted
parts can lead to severe injuries up to
and including death.
ÂThis tool can only be operated, if all parts
are fully fitted and tightened and there
are no damaged parts!
¾ Therefore first read the entire chapter,
before fitting the parts.
¾ Fit the parts carefully and completely.
¾ Use tools as specified.
Risk of injuries
¾ Parts may only be fitted and removed
when the motor is switched off and the
power pack removed.
Attaching the handle A B C
Place the U-shaped grip A d over the device
Î
housing B 1 .
Push the fixing screw through the U-shaped grip
Î
and the housing B 2 .
Apply the fixing screw B 3 .
Î
Select your preferred working angle C 1 .
Î
Lock the U-shaped grip by pushing the quick-re-
Î
lease lever in C 2 .
Attaching the blow/vacuum pipe A D E
Press the top blow/vacuum pipe A a a onto
Î
the housing of the device until it audibly latches
in D 1 .
Fix the top vacuum/blow pipe with the
Î
screw A h D 2 .
Press the top blow/vacuum pipe A b a onto
Î
the housing of the device until it audibly latches
in E 1 .
Fix the bottom vacuum/blow pipe with the
Î
screw A h E 2 .
WARNING!
WARNING!
EN
21