10 m. FlatGrid is not recommended for roofs with more than a 10-degree slope. For slopes of 3° and more, additional fastening may be needed on the roof. The surface load must not exceed the building’s residual load capacity! For static reasons, at least two contiguous rows of modules must be installed.
Page 4
• Place Rapid 2+ L onto the profile, align it, and fasten it with a screw and shim. Installation manual FlatGrid | 2020.03 V.001 Schletter Solar GmbH – Alustraße 1 – 83527 Kirchdorf, Germany...
Page 5
If the load distribution is uneven, bring the loads close to the module support profile. Ballast is not included with FlatGrid. Recommended stone dimensions: 20x10x8cm Installation manual FlatGrid | 2020.03 V.001 Schletter Solar GmbH – Alustraße 1 – 83527 Kirchdorf, Germany...
Page 6
15 Nm. More information on our systems can be found at our website: www.schletter- group.com in the Downloads area. Installation manual FlatGrid | 2020.03 V.001 Schletter Solar GmbH – Alustraße 1 – 83527 Kirchdorf, Germany...