Related Manuals for Schletter SECT
Summary of Contents for Schletter SECT
- Page 1 SECT INSTALLATION MANUAL SECT (patent pending) in flush, north or east-west variants.
-
Page 2: Table Of Contents
6.2. Cable trays on a concrete roof..................13 6.3. Cable trays on another channel .................. 13 7. ELECTRICAL DESIGN CONSIDERATIONS ................. 14 8. MAINTENANCE .......................... 14 SECT | V1 | INSTALLATION MANUAL | 202102 SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES... -
Page 3: Sect Installation Guide
Injury hazard! Falling objects pose a risk of injury to people. Prior to installation, set up barriers in the hazard area to warn people nearby. SECT | V1 | INSTALLATION MANUAL | 202102 SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES... -
Page 4: Introduction
16641.1:1997 on aluminium structures. 1.1. Overview SECT solar PV arrays are assembled on the roof using channel (or rail), brackets and clamps. The product is suitable for commercial format modules (approximately 2 m x 1 m) with frame heights of 35 mm. Modules are held in one of three possible orientations: 10°... -
Page 5: No Reach' Installation
Edge bracket SPEB-40 Centre bracket SPCB-40 Flush bracket SPFB-40 1.5. Types of roof fixings SECT can be fixed to the roof using: roof clamps with EPDM rubber sheets, channel feet on roof screws, or ... -
Page 6: Layout And Assembly
2. LAYOUT AND ASSEMBLY 2.1. Fixing spacing When SECT is installed in columns, the fixing spacing (distance between channel feet) is equal to the purlin spacing, because a channel foot is used at each point where a channel crosses a purlin. -
Page 7: Assembly
6. Continue to assemble the entire column or row. SECT east-west SECT | V1 | INSTALLATION MANUAL | 202102 SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES... - Page 8 SECT north, assembled using the same brackets as for east-west. Assembly of SECT flush is even simpler, using the SPFB-40 flush bracket. SECT flush, assembled using SPFB-40 brackets. SECT | V1 | INSTALLATION MANUAL | 202102 SCHLETTER SOLAR GMBH | SUBJECT TO CHANGES...
-
Page 9: Joining Channels
Every solar PV installation needs to comply with applicable codes and standards, including for earthing the PV module frame and array frame. On each SECT, the module frames are electrically earthed to the array frames via the stainless-steel module clamp plates. Each module is held using two clamps plates. -
Page 10: Installation Using Roof Clamps
3. INSTALLATION USING ROOF CLAMPS SECT can be installed on roof clamps. Channel feet are supplied as an assembly with the roof clamp. Use product codes: SPCF305 (SECT Channel Foot 305), to suit a variety of standing seam roof sheet profiles, ... -
Page 11: Installation Using Roof Screws
4. INSTALLATION USING ROOF SCREWS SECT can be installed using roof screws that fix into purlins. Use the product code SPCF01 (SECT Channel Foot 01), to suit standard 14g roof screws. SPCF01 with EPDM on the base The channel foot is supplied with an EPDM mat fixed to the base. The EPDM mat prevents water ingress. -
Page 12: Installation Using Concrete Anchors
5. INSTALLATION USING CONCRETE ANCHORS SECT can be installed on a concrete roof. Use the product code: SPCF05 (SECT Channel Foot 05), with a 9 mm hole in the base to suit a M8 anchor. Standard M8 chemsets can be used to fix a SPCF05 channel foot. -
Page 13: Cable Trays On A Concrete Roof
6.3. Cable trays on another channel Channel (as cable tray) can be fixed on top of the main channels using product code SPCF03 (SECT Channel Foot 03), which comprises a channel foot with a M8 fastener and channel nut. SECT channel used as cable tray, fixed on top of base channels. -
Page 14: Electrical Design Considerations
8. MAINTENANCE The mill-finish aluminium used in SECT is largely maintenance free. Only in highly polluted or marine conditions is rinsing with clean water required, during scheduled panel cleaning. Further information regarding our systems is available on our website: www.schletter-group.com under Downloads in the solar section. - Page 15 SCHLETTER SOLAR GMBH Alustrasse 1 83527 Kirchdorf GERMANY www.schletter-group.com We reserve the right to changes, including technical modification.