Before First Use; Check The Following Before Start-Up; Preparing The Filter Vessel - Steinbach Comfort 50 Original Owner's Manual

1. Switch the pump
power plug.
2. Press and hold down the valve lever
the valve head
3. Set the valve lever to the "FILTER" position
and release it.
In the case of very dirty water, you can
select the "WASTE" mode alternatively
(see section "Modes").
The floor cleaner is connected to the filter system.

Before First Use

Check the following before start-up

1. Make sure that the pump's power cable is disconnected from the power supply.
2. Make sure that the device is located outside the pool and below the water level.
3. Make sure that all feed and drain lines are correctly connected and fastened in place.
4. Make sure that the pool's water level is at least 2.5 to 5 cm above the opening of the
suction line. If this is not the case, top up the pool.
5. Remove the stopper on the suction line if applicable.
6. Open the shut-off valve on the suction line.
The filter system fills automatically with water because it is below the water level.

Preparing the filter vessel

1. Fill the filter vessel
1/3 with water.
2. Fill the filter chamber
medium.
Please refer to the section "Technical
data" for the required quantities.
Make sure that no filter medium gets
into the clean water chamber
off by pulling the
10
.
1
approximately
32
with filter
31
.
32
2
on
35
3
32
31
53