Maintenance - Tetra EasyCrystal FilterBox 600 Instruction Manual

UK
Switching the EasyCrystal FilterBox on/off
NOTE
The device is switched on when the plug is inserted into a
socket. It is switched off (no power) when the plug is pulled
out.
Procedure:
Fig. E
1. Insert the power supply plug in the socket.
– The lowest point of the power cable must be below the
socket to prevent any water dripping down from entering
the socket.
Adjusting the current
Procedure:
Fig. F
1. Position the slider so that the water flows in the desired
direction.

MAINTENANCE

WARNING
Before performing any work on the device, remove the plug
from the socket to prevent a harmful electric shock.
Changing the EasyCrystal filter cartridge
For optimum water quality, you should replace the filter cartridge
every three to four weeks.
We recommend that new filter cartridges with activated carbon
are washed out with tap water before use.
Procedure:
Fig. G
1. Pull the filter clip out of the FilterBox by the tab in the middle.
2. Press the clamp grips together so that both clamps open.
3. Remove the used filter cartridge and place the new filter
cartridge in the middle between the clamps.
– The protruding corner of the filter cartridge must be on the
right when viewed from the front!
4. Insert the filter clip with the filter cartridge into the FilterBox
until the filter clip is flush with the lid.
10
EasyCrystal FilterBox 600