Challenge Xtreme CX-CS 860 L Original Operating Instructions page 15

10 11
A a C B D
6.6 Replacing the drive belt (Fig. 10-11)
The drive belt (B) must be replaced if it is worn.
Undo the screw (a) and remove side belt cover
(A).
Remove the worn drive belt (B) and clean the two
belt pulleys (C/D).
Place the new drive belt on the belt pulley (C) and
pull the belt onto the belt pulley (D) whilst turning
the shaft.
Make sure that the drive belt is properly seated
on the belt pulleys.
Fit the belt cover (A) and secure it with the screw
(a).
Helpline No 0844 801 8701 / IRE 189 094 6244
14