Timer Operations - Aiwa XR-EM200 Operating Instructions Manual

TIMER OPERATIONS

POWER
6STANDBY/ON
Sleep timer
Turns off the unit automatically after a specified time.
Press SLEEP on the remote.
"SLEEP" flashes in the display.
With each press, the timer duration changes as follows:
AUTO 90 MIN
OFF 10 MIN...70 MIN
If you set to "AUTO", the unit turns off automatically when
the current CD or tape finishes playback or elapsed 100
minutes.
To check the remaining time until the unit turns off
Press SLEEP on the remote. The remaining time is displayed
for 6 seconds.
To cancel the sleep timer
Press SLEEP on the remote repeatedly so that "OFF" is
displayed.
14
POWER
TIMER
VOLUME
f,g
SHIFT
SLEEP
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Press VOLUME +, - to set the volume level.
2 Hold down SHIFT and press TIMER on the remote
80 MIN repeatedly so that "5" and "PLAY" are displayed.
3 Within 6 seconds, press ENTER.
"ON TIME" is displayed.
4 Press f or g to set the timer start hour,
and press ENTER.
5 Press f or g to set the minute, and press
ENTER.
"OFFTIME" is displayed.
6 Set the time to stop playback by following the
same procedures as steps 4 and 5.
7 Press f or g to select the source (CD, TAPE
and TUNER), and press ENTER.
8 Prepare the source.
To play CD, load a disc.
To play a tape, insert a tape.
CLEAR
To play the radio, select the band and tune in the desired
station.
ENTER
f,g
9 Press POWER 6STANDBY/ON (POWER) to turn
the unit off.
VOLUME
"5" remains in the display to indicate the timer standby
+,-
mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
•To stop timer setting in steps 4 to 6, press CLEAR.
Timer standby mode is also cancelled.
•The timer playback is not activated when the clock is not
set. ("SET NG" is displayed.)
•Timer playback will not begin unless the unit is turned off
first.
•Timer playback for AUX source is not possible.