Specification - Quer CRUISER 2.0 Owner's Manual

2. Place the cruiser on flat and even ground. It's important to make sure that both
wheels are on the same level.
3. Once you have made sure that both wheels are positioned correctly and the device is
stably placed on even ground, press and hold the power button for about 5 seconds,
until the red indicator starts to flash.
4. When the red indicator stops to flash, the calibration is finished.
5. Power off and then power on the device again. The cruiser is ready to use.
• Do not clean this device when in the process of charging!
• Clean the unit's exterior periodically with a soft, slightly damp cloth. Never use
chemical agents to clean this device.
• Do not store the vehicle if its battery level is very low or discharged. Charge the
battery before storage to prevent battery over-discharge due to a long time non-use.
• Charge the device's battery every two months if the vehicle is left unused to maintain
the longevity of the battery.
• Do not wrap up the device after fully charging it. If you want to store it in the package,
leave it in its partially charged state. Do not take it out of the package to make it to a
full charge and then wrap it back up.
• Power: 2x350 W
• Minimum load: 20 kg
• Maximum load: 120 kg
• Maximum speed: 12 km/h
• Range per charge: up to 20 km*
• Maximum slope: 20º
• IP rating: IP54
• Chassis height: 37 mm
• Pedal height: 125 mm
• Wheel size: 6,5"
• Built-in Bluetooth speaker
• Bluetooth range: up to 20 m
• Weight: 10,5 kg
• Power supply: AC 100~240 V; 50/60 Hz
* please note, range is directly dependent on numerous factors and it represents
maximum approximate value
Owner's manual
CLEANING
STORAGE

SPECIFICATION

EN
19