Battery And Charging - Quer CRUISER 2.0 Owner's Manual

Always check the battery level before using. Do not ride when its battery is low! Flashing
green or red indicator signalize low battery. In such case, stop using the vehicle and
charge it. Do not continue using the vehicle, as the system will automatically tilt the base
of the platform to prohibit using the device – risk of falling is increased!
• Do not use the device if the battery gives out any odor or excessive heat or when
there's leakage.
• Do not use the device when it is charging!
• Ensure the charging port is dry prior to charging!
• Charge the vehicle only with the included/authorized charger.
1. Plug the charger into mains socket (100 – 240 V; 50/60 Hz). The indicator on the
charger lights up green.
2. Plug the other end of the charger into the vehicle. The indicator on the charger will
turn red.
3. When the indicator turns from red to green, the charging is complete. Disconnect
charger from the device and power mains outlet. Do not overcharge the device, as
it may affect battery life.
• Rechargeable lithuim-ion battery
• Voltage: 36 V
• Capacity: 4,4 Ah
• Working temperature: -10ºC~+50ºC
• Charging temperature: 0ºC~+40ºC
• Relative storage humidity: 5~95%
• Charging time: up to 120 minutes
EN
The cruiser is ready to use after unpacking.
During use, especially when driving on uneven ground, the device may get decalibrated.
Decalibration of the device causes the cruiser unsuitable for further use, which is
signalized by flashing red indicator on the device. In such case, it is necessary to perform
a calibration. Calibration will tune the gyroscope and its sensors, which might have
gotten distorted as a result of shocks or impact during driving.
To calibrate the device:
1. Make sure the device is powered off.
18
Owner's manual

BATTERY AND CHARGING

Battery
Charging
Specifications of battery
CALIBRATION OF THE DEVICE