Techfrost E Series User Manual page 32

to go back to its original location.
The chiller is very heavy. When a transfer is needed, the use of gloves is highly
recommended, since you may find protruding parts on its back, sides and bottom.
When the " DEEP-FREEZING " process is over, you should pull food containers out by using dry glo-
ves or cloths.
Do not open the machine door while executing its working cycle because you may prevent the proper
accomplishment of the cycle itself.
The constructor is not liable for damages arising from improper use or installation, connection to
non-authorized equipments, use of non-original fittings as well as tampering by non-authorized per-
sonnel.
1.6 Technical assistance
Post-sale technical assistance can be carried out by any licensed refrigeration technician. The com-
pany is available to provide indications on how to intervene technically through the AFTER SALES
service by writing to the e-mail address info@techfrost.com.
2 REGULAR MAINTENANCE
2.1 Warnings
Regular maintenance work can be carried out by non-specialised personnel who, however, must
always adhere to the instructions given in this manual. Before cleaning or servicing the chiller lockoff
the power supply. When carrying out regular maintenance work do not remove any of the safety
guards.
2.2 Cleaning the chiller and accessories
Before using this Chiller clean on the inside and all the accessories. Use warm water and neutral soap.
Rinse and dry well. Do not use solvent or powder based detergents and use a silicon wax to protect
the steel.
2.3 Periodically cleaning the condenser
The condenser should be cleaned periodically. Cleaning intervals will depend on how frequently it
is used.
CAUTION: To access the condenser it is necessary to remove the safety guards. Always use qualified
and specialised personnel.
To guarantee efficiency and performance in time, it is necessary to clean the
condenser periodically. It is highly recommended if located in dusty environ-
ments to clean the louvers on the refrigerating unit once a month and once
every three months if located in closed and clean environments. To remove
dust and dirt from the louvers use a brush or vacuum cleaner. Do not use sharp
objects or tools that could damage the condenser. Do not clean using water
jets.
32
www.techfrost.com