Electrical Connection - Pelgrim STM550RVS User Manual

Before connecting the steamer
Warning:
Ensure that your appliance has not
suffered any damage during transport
(deformed seal or door, etc.). If you see
any kind of damage, before doing
anything else, contact your retailer.
In order to easily locate the reference
information for your appliance, we
recommend that
information on the "After-Sales Service
Department and Customer Relations"
page.
Electrical connections
Ensure that:
- the electrical installation has sufficient
voltage.
- the electrical wires are in good condition.
- the diameter of the wires complies with the
installation requirements.
- your electrical installation is equipped with 16-
ampere thermal-sensitive protection.
In case of doubt, consult your electrician-
installer.
The electrical connections are made before the
appliance is installed in its housing.
The appliance must be installed correctly to
ensure electrical safety. During installation and
maintenance operations, the appliance must be
unplugged from the electrical grid; fuses must
be cut off or removed.
The oven must be connected with a power cable
(standardised) with three 1.5 mm² conductors
(1 ph +1 N + ground) that must be connected to
a monophase 220-240 V network via a CEI 60083
standardised receptacle (1 ph +1 N + ground
lead) or in accordance with installation rules.
The safety wire (green/yellow) is connected to
the appliance's terminal and must be connected
to the installation earth
you note this
.
In the case of connections with an electric
receptacle, it must remain accessible after
installation of the appliance.
The oven's neutral conductor (blue wire) must
be connected to the network's neutral
conductor.
In the electrical connection, ensure there is a
means available to the user to ensure they are
able to disconnect the appliance from the outlet,
either by pulling the plug from the outlet or by
turning off a switch, in compliance with
installation rules.
If the power cable is damaged, it should be
replaced by the manufacturer, its after-sales
service department or by a qualified person to
avoid danger.
Warning:
We cannot be held responsible for
any accident resulting from a non-
existent, defective or incorrect earth
lead.
If the steamer malfunctions in any way,
unplug the appliance or remove the fuse
corresponding to the sector where the
oven is hooked up.
It is dangerous for anyone other than a
qualified person to perform maintenance
operations or repairs.