Table of Contents
Advertisement
6. Line up the spool with the pump isolation
valve on the manifold-discharge pipe and
set the pump on the skid. Start threading
the base bolts on the pump head. Slide
the Victaulic clamp gasket so that the
clamp rides in the gloves on both the
isolation valve and the spool. Tighten the
Victaulic clamp. Tighten the base bolts.
7. If the pumps are shipped unassembled,
refer to the Gould Pumps, Model VIT
Installation, Operation, & Maintenance
Instructions.
8. Install the vertical hollow shaft motor to
the top of the pump's disconnected head.
Refer to the Gould Pumps, Model VIT
Installation, Operation, & Maintenance
Instructions.
WARNING: Falling Objects Hazard
DO NOT work under heavy suspended object
unless there is positive support and safeguards
should a hoist or sling fail.
Failure to follow these instructions could result in
serious
personal
injury,
damage.
CAUTION: Motor Rotation Hazard
DO NOT install motor shaft, Gib key, or adjusting
nut until motor rotation has been verified.
Failure to follow these instructions indicates a
potentially hazardous situation, which, if not
avoided, may result in property damage.
death,
or
property
10
Advertisement
Table of Contents
