Mounting The Bike Handle - Stihl FS 85 Instruction Manual

Mounting the Bike Handle

Versions
The trimmer comes in versions with a
fixed handle support and a swiveling
handle support.
1 2
1 Version with fixed handle support –
see "Mounting Bike Handle with
Fixed Handle Support".
2 Version with swiveling handle
support – see "Mounting Bike
Handle with Swiveling Handle
Support".
Mounting Bike Handle with Fixed
Handle Support
The fixed handle support is supplied
separately and must be mounted to the
drive tube.
FS 85, FS 85 R
Mounting the Handlebar
6
6
5
1
4
A
2
Mount the handlebar (1) on the
N
drive tube (2) about 40 cm (16 in)
(A) from the engine.
Place the clamp (3) and handle
N
support (4) against the drive tube.
Fit the handlebar (1) in the handle
N
support – the rubber handle must be
on the left (viewed from the engine).
Place the clamp (5) on the handle
N
support.
Insert the screws (6) through the
N
holes in the parts and screw them
into the clamp (3) as far as stop.
Line up the handlebar.
N
Tighten down the screws firmly.
N
Mounting the Control Handle
9
3
8
Take out the screw (7) – the nut (8)
N
remains in the control handle (9).
Push the control handle onto the
N
handlebar (1) until the holes (11)
line up – the throttle trigger (10)
must point towards the gearbox.
Insert the screw and tighten it down
N
firmly.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
English
10
11
7
1
11
65