Vex Robotics Falcon 500 User Manual page 34

217-6515-751
Falcon 500 Motor User Guide
Step 6: Use (5x) M2.5 Screws to Secure the New Shaft to the Motor
Using a 2mm hex key and the (5x) 2.5mm screws that were removed in Step 4, secure the new output shaft
to the rest of the motor assembly.
Step 7: Install the Front End Cap on the Motor Chamber
Reinstall the front end cap that was removed in Step 2.
NOTE: The front end cap is keyed to the sleeve of the motor chamber. If the end cap doesn't seat correctly,
turn it 120˚ until it does.
assembly.
front
end
cap to
the
rest of
the
motor
vexpro.com ctr-electronics.com
Copyright 2019, VEX Robotics Inc.
2020-01-07
34