Vex Robotics Falcon 500 User Manual page 26

217-6515-751
Falcon 500 Motor User Guide
Step 1: Determine the Approximate Location of the Gear/Pulley on the
Shaft
Determine where you want your pinion and pulley to
be located on the Falcon 500's spline shaft. In this
example, we want the GT2 pulley to be 5/16" away
from the end of the shaft.
Step 2: Install Washers Between
the Shaft's Shoulder and Gear (if necessary)
Based on the table at the beginning of this section,
the first item installed on the shaft is a 1/8" thick
spacer.
shaft.
Step 3: Install gear/pulley on motor shaft
Slide (1x) of either a pulley or a motor pinion onto the motor shaft.
Step 3:
Install
gear/pulley on motor shaft
Slide (1x) of either a pulley or a motor pinion onto the motor
shaft.
vexpro.com ctr-electronics.com
Copyright 2019, VEX Robotics Inc.
2020-01-07
26