Install Gear/Pulley On Motor Shaft - Vex Robotics Falcon 500 User Manual

217-6515-751
Falcon 500 Motor User Guide
Step 3: Install Gear/Pulley on Motor Shaft
Slide (1x) of either a pulley or a motor pinion onto the
motor shaft.
Step 4: Install Washers Between the Gear/Pulley and the End of the Shaft
(if necessary)
The next step is to install the washers on the end of the
shaft. Based on the table at the beginning of this section,
(1x) 1/4" spacer and (1x) 1/16" spacer is used on the
end of the shaft.
and the pulley or
pinion.
vexpro.com ctr-electronics.com
Copyright 2019, VEX Robotics Inc.
2020-01-07
27