Sd Card Slot; Buttons; Connectors - Axis Q1615-LE Mk III User Manual

AXIS Q1615-LE Mk III Network Camera
Specifications

SD card slot

NOTICE NO NO TICE TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects, or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Unmount the SD card
from the product's webpage before removal.
This product supports microSD/microSDHC/microSDXC cards.
For SD card recommendations, see axis.com.
microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC. microSD, microSDHC, microSDXC are
trademarks or registered trademarks of SD-3C, LLC in the United States, other countries or both.

Buttons

Control button
The control button is used for:
• Resetting the product to factory default settings. See Reset to factory default settings on page 19.
Function button
Note
Focus assistant is only valid for optional P-iris, DC-iris or manual iris lenses.
Use the function button to activate the following functions:
Leveling assistant - This function helps to make sure the camera is level. To start the leveling assistant, press the button for about
3 seconds. Press again to stop the leveling assistant. The status LED and buzzer signal assist leveling of the camera, see Status LED
behavior and buzzer signal for leveling assistant on page 25. The camera is level when the buzzer beeps continuously.
Focus assistant - This function is used for enabling the focus assistant. To enable the focus assistant, press and very quickly release
the button. Press again to stop the focus assistant. To find out more, see the Installation Guide.

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
Audio connector
• Audio in – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A stereo connector must be used for audio out.
Audio input
26