Yakima HullRaiser Installation Instructions

Yakima HullRaiser Installation Instructions

Roof racks
Hide thumbs Also See for HullRaiser:

Advertisement

Quick Links

HEAVY DUTY STRAP (2X)
BOW STERN TIE DOWN
Buckle Strap (2X)

IMPORTANT WARNING

IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO
OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR
TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ
AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION
OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE
AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A
PROFESSIONAL INSTALLER SUCH AS A QUALIFIED GARAGE OR AUTO BODY SHOP.
MiniMuM
Crossbar
HULL RAISER
(2X)
Plastic Tube (2X)
spread 24"
WRENCH (1X)
— CARRIAGE BOLT (4X)
— SNAP AROUND (4X)
— HEX KEY (4X)
BASE PAD (2X)
Plain Strap (2X)
MIGhTyMOuNTs
must use kit #8860007.
See your dealer.
PLUG (16 X)
Steel Hook (2X)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HullRaiser and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Yakima HullRaiser

  • Page 1 Plain Strap (2X) IMPORTANT WARNING IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO OTHERS.
  • Page 2 Attach SnapArounds or MightyMounts in the same direction on each bar. FaCTory Crossbars If your MightyMounts require bar caps, install them now. MightyMounts must use kit #8860007 available from your YAKIMA dealer. Choose Carrier posiTion on vehiCle. FaCTory Large round holes in bases must Crossbars face the rear of the vehicle.
  • Page 3 MightyMounts must use kit #8860007 Make sure bolts are fully seated in base. available from your YaKIMa dealer. • Use longer hex bolts with hex wrench from kit. • TIGHTEN COMPLETELY. • Continue at step 7.
  • Page 4 • Tighten again if loose. • REAd ALL CAUTIoNS ANd LImITS oN NExT PAGE. see your aCCessory check straps periodically during travel and tighten if necessary. replace any straps that are worn or insTruCTions For frayed before using (see your Yakima dealer). iMporTanT warnings...
  • Page 5 Follow the yakiMa Fit list for your rack’s weight limit. do not exceed the weight limit of your vehicle’s racks. Maximum weight is 165 lbs. (75 kg) unless otherwise noted. IF YOU REMOVE YOUR CARRIER, FOLLOW INSTRUCTIONS TO INSTALL AGAIN.

Table of Contents