Care Of The Fst Chair (Fixed Track); Disinfection; Cleaning - Ferno FST User Manual

Ferno Slovakia FST Chair ( Fixed Track)
Head end operator leans the Chair backwards until the patient's
weight is on the transport wheels.
At this point, the lower handle is more easily accessible to the foot
end operator. The Chair can then be rolled towards the foot of the
stairs. Position both track assemblies squarely against the facing
edge of the step. The operators can then move the Chair up the stairs
by pushing (foot end operator) and pulling (head end operator).
The head end operator is responsible for guiding the Chair up the
stairs whilst the foot end operator assists as required.
If there is a need to manoeuvre the Chair on stairs the head end
operator may need to adjust the upper handle to a higher or lower
position.
TO PAUSE DURING DESCENT
To pause during the descent, tilt the Chair forward just enough to
allow the rear wheels to rest on the step while both operators hold
the Chair in place. To continue down the stairs, tilt back the Chair
and regain the glide angle (see step 5 above)
Up Stairs: Once the patient is seated on the Chair and restrained,
adjust the upper handle into a position that is comfortable for your
height. (See Section Upper Handle). The upper handle position can
be changed to provide a better hand grip.
Always inform the patient about what is happening.

6. Care of the FST Chair (Fixed Track)

6.1. Disinfection

Disinfect all surfaces of the Chair including the head pad and patient restraints. Follow disinfectant
manufacturers' directions for use. Spray or wipe disinfectant onto the patient restraints. Do not immerse in
disinfectant.

6.2. Cleaning

Clean the Chair and its components with a clean cloth or soft brush and warm soapy water. Rinse with
warm water and air dry. Do not clean with products containing bleach or phenol. A stiff bristled brush can
be used if necessary.
22