Advertisement
4.
Your program is now set, turn the wheel to the AUTO symbol to complete setup. Programming is now complete and the product is now
ready to operate.
5.
You have a few options when the need arises to manually over-ride the program, for example when leaving the house for a short period
to go shopping or a long period when on holiday.
a.
Option 1: Quick Over-ride Button.
After a few seconds the screensaver activates, showing the room temperature. Press the i button or turn the wheel to access the menu
b.
Option 2: Holiday Mode
Turn the wheel to the
screen will then display the number of days away on holiday and the
will maintain the temperature set for frost protection and will revert to normal at midnight on the morning of your return.
Wireless Configuration: 137, 147
Remember: the product comes pre-associated; the following information is in the event that association is lost or configuration is restored to
factory settings.
1. On the receiver, press and HOLD the button for 3 seconds, until the LED begins to flash.
137 Receiver
2. On the transmitter room unit, turn the menu wheel to the
Then press the R button and ensure that menu r-01 shows 0, press OK. Finally press the i button to initiate association. The screen should now
show rAd 1. Your product is now associated, confirm this by checking the LED on the receiver, which should now have stopped flashing.
Additional Information: Receiver Button Functions
Association Mode
Reverse the relay contact (NO/NC)
Delete All Wireless Associations
symbol to initiate holiday mode. Set the date of your return from holiday using the +, - and OK buttons. The
=
Press and HOLD for 3 seconds (LED slow flashing)
=
Press and HOLD for 10 seconds (audible click)
=
Press and HOLD for 30 seconds (LED rapid flash & off)
wheel. When in AUTO mode, the screen will display the set temperature and
either the
or
in the top right. This is the current program status, either
comfort or setback mode. By pressing the button you quickly switch between
the two temperature-modes previously set. When the program is in over-ride,
the symbol will display a hand next to it as shown above. Note: the program
will remain in the over-ride state until either pressing the button again or at the
end of the previously set program.
to show that the mode is correctly configured. The program
147 Receiver
symbol and press the i button for 5 seconds to enter configuration mode.
Advertisement
