Safety Labels - Champion 100641 Operator's Manual

100641 - ChAiNSAw

Safety Labels

These labels warn you of potential hazards that can cause serious injury. Read them carefully.
If a label comes off or becomes hard to read, contact Technical Support Team for possible replacement.
b
C
a
B
3mm corner radius; 2mm safe margin; to be printed
on white substrate
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for
C
outside parties without the explicit consent of Champion Power Equipment.
5
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for
outside parties without the explicit consent of Champion Power Equipment.
LaBEL
WARNING AVERTISSEMENT
− Only use approved bar and chain combination.
− Bar/Chain Oregon, type 188PXBK095 / 21BPX072X.
− Sprocket (teeth × pitch): 7T × 0.325 in.
− Class 1C
− Use of non-approved bar, chain or sprocket will void
warranty, damage the saw and could cause physical
harm.
45
− Utilisez uniquement la combinaison de barre et de
chaîne approuvée.
− Bar / Chaîne Oregon, type 188PXBK095 / 21BPX072X.
−
Pignon (dents × pas) : 7T × 0,325 po.
−
Clase 1C
−
L'utilisation d'une barre, d'une chaine ou d'un
pignon non approuve annulera la garantie,
endommargera la scie et pourrait causer des
blessures.
MODEL
100XXX
LPN 1687-L-SF
MODÉLE
SERIAL NO.
Rev XXXXXXXXXXXX D
N° DE SÉRIE
Size 45 x 33 mm
MANUFACTURE DATE XXXX
DATE DE FABRICATION
Conforms to / Obéir à OPEI B175.1
Artwork Notes Certified to / Certifier à CSA z62.1. z62.3
10-20X
1-4X
1 2 3 4 LPN 1696-L-PR
Always wear protective gear.
Do not wear loose fitting clothing. /
Rev A
1-4X
Portez toujoursde l'équipement de
6 7 8 9
protection. Ne portez pas de
Size 70 x 35 mm
vêtements amples.
Artwork Notes
2mm safe margin; to be printed on security ---
substrate ; magenta text should be filled in during
time of production.
A
Top view
Colors
K 152 485 2945
5005032 Revision Changes
1696-L-PR-A
B -revised lineart.
C-change
21BPX072X to 91P062X
D-change back to 21BPX072X
Colors
Read operator's manual
before operating saw. / Lisez
le manuel d'utilisation avant
K --- d'utiliser la scie. --- --- ---
1693-L-OP-B
Revision Changes
8
iMPORTANT SAfETY iNSTRUCTiONS
DESCRIPTION
Safety Symbols
---
Quick Start
Dataplate