Table of Contents
Advertisement
100641 - ChAiNSAw
Quickstart Label Symbols
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to more safely operate the product.
Starting the Engine
1. Make sure chain break is engaged.
2. Push the purge bulb at least 10-20 times, or until bulb is full
of fuel.
3. Pull the choke knob out until a "click" is heard.
4. Pull the starter rope rapidly 1-4 times or until the engine
pops.
5. Push the choke knob in.
6. Pull the starter rope rapidly 1-4 times to start the engine. If
the engine does not start, repeat steps 3-6.
7. When engine starts, ensure the choke knob is pushed in and
press and hold the throttle lockout and lightly squeeze the
throttle to idle the engine.
8. Allow the engine to warm up for 30-60 seconds.
9. Carefully disengage the chain brake.
1
2
1-4X
5
6
7
Artwork Notes
2mm safe margin; to be printed on white substrate.
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall
outside parties without the explicit consent of Champion Power Equipment.
iMPORTANT SAfETY iNSTRUCTiONS
10-20X
1-4X
3
4
8
9
LPN
Rev
Size
10
Always wear protective gear.
Do not wear loose fitting clothin
Portez toujoursde l'équipement
protection. Ne portez pas de
vêtements amples.
1693-L-OP
B
26 x 126 mm
Revision
---
K
Advertisement
Table of Contents
