Safety Labels - Champion 100647 Operator's Manual

100647 - ChAiNSAw

Safety Labels

These labels warn you of potential hazards that can cause serious injury. Read them carefully.
If a label comes off or becomes hard to read, contact Technical Support Team for possible replacement.
a
3mm corner radius; 2mm safe margin; to be printed
on white substrate
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for
outside parties without the explicit consent of Champion Power Equipment.
A
LaBEL
WARNING
AVERTISSEMENT
− Only use approved bar and chain combination.
− Bar/Chain Oregon, type 180SDEA041 / 91P063X.
− Sprocket (teeth × pitch): 6T × 0.375 in.
− Class 1C
− Use of non-approved bar, chain or sprocket will void
warranty, damage the saw and could cause physical
harm.
45
− Utilisez uniquement la combinaison de barre et de
chaîne approuvée.
−
Bar / Chaîne Oregon, type 180SDEA041 / 91P063X.
−
Pignon (dents × pas) : 6T × 0,375 po.
−
Clase 1C
−
L'utilisation d'une barre, d'une chaine ou d'un
pignon non approuve annulera la garantie,
endommargera la scie et pourrait causer des
blessures.
LPN 1786-L-SF
Rev B
Size 45 x 33 mm
Artwork Notes
B- revised lineart
iMPORTANT SAfETY iNSTRUCTiONS
Top view
Colors
K 152 485 2945 ---
Revision Changes
DESCRIPTION
Safety Symbols
8