100647 - ChAiNSAw
Quickstart Label Symbols
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to more safely operate the product.
Starting the Engine
1. Engage.
Engage the chain brake.
2. Prime.
Slowly press and release the primer bulb 4-6 times.
3. Choke.
Pull choke knob out.
4. Start.
Set the unit on a flat surface and hold securely; pull recoil
Start rope. When engine starts, allow the saw to warm up for
30-60 seconds before cutting logs. If engine does not start
after 4 pulls, go to step 6.
5. Depress.
Depress the choke knob.
6. Start.
Pull recoil start rope 1-4×.
7. When engine starts, squeeze the trigger to automatically
2mm safe margin; to be printed on white substrate.
release the choke and allow the saw to warm up for 30-60
seconds before cutting logs.
8. Disengage.
Disengage the chain brake.
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and s
outside parties without the explicit consent of Champion Power Equipment.
Artwork Notes
iMPORTANT SAfETY iNSTRUCTiONS
Always wear protective gear. Do
wear loose fitting clothing. / Por
toujoursde l'équipement de
protection. Ne portez pas de
vêtements amples.
LPN
1693-L-OP
Rev
A
Size
26 x 126 mm
---
Revis
10