Table of Contents
Advertisement
C
1
3
D
HOLD
RESUME
OFF
E
F
G
1
3
2
DC 5~6 V
CHARGE
STOP/OFF
PLAY/
PAUSE
STOP/OFF
DSL
PHONES/
LINE OUT
2
H
USING ON RECHARGEABLE BATTERIES
• Be sure to use size AA Ni-Cd 1.2 V 700 mAh rechargeable batteries,
which are commercially available.
• Be sure to read the instructions of the purchased rechargeable batteries
before use.
• When using on rechargeable batteries for the first time, charge them until
the battery indicator goes out.
• Before charging the batteries, close the disc compartment. You cannot
charge the batteries while it is opened.
1 Insert the rechargeable batteries with the 0 and 9 marks
correctly aligned.
2 Connect the AC adaptor.
Pull out the rubber cap before connecting the adaptor.
1 to DC 5 ~ 6 V jack
2 to wall outlet
3 Keep sSTOP/OFF/CHARGE pressed for about 1 second to
start charging.
"C-on" is displayed and the battery indicator blinks.
After charging, disconnect the AC adaptor.
Time to recharge the batteries
Recharge the batteries when
lights, "Lo-bAtt" is displayed and the current operation will stop.
To stop charging
Press sSTOP/OFF/CHARGE during charging.
ATTENTION:
CHARGE
The product you have purchased can be powered
by nickel cadmium batteries which are recyclable.
At the end of their useful life, under various state
and local laws, it is illegal to dispose of these
batteries into your municipal waste stream.
Please call 1-800-289-2492 for information on how
to recycle these batteries.
USING ON AC HOUSE CURRENT
Connect the supplied AC adaptor in the same way as when recharging the
batteries.
During operation on AC house current, all of the battery indicators disappear.
BEFORE PLAYBACK
HOLD switch
Release the HOLD switch before playback.
When not using the unit, set the HOLD switch to the HOLD position.
Accidentally pressed button will not function.
If buttons are pressed when the HOLD switch is set to the HOLD position,
"HOLd" flashes in the display.
Turning on and off
Turning the power on
Press e PLAY/PAUSE. Power is turned on and playback starts.
Note
"Err" appears on the display in the following cases:
– When you try to play the unit without a disc in the disc compartment.
– When you play a disc placed upside-down or a defective disc.
Turning the power off
If no new operations are done within 30 seconds from the end of last
operation, the power is turned off automatically. (Auto power off function)
• You can turn off the power before it is automatically turned off by pressing
sSTOP/OFF/CHARGE.
Standby mode
When an operation finishes, the unit goes into standby mode until the auto
power off function automatically turns off the power.
To enter standby mode, press e PLAY/PAUSE to start playback, then
press sSTOP/OFF/CHARGE.
Adjusting the sound
Volume
Press + to increase the volume.
Press - to decrease the volume.
DSL
Press DSL for more powerful sound and deeper bass.
: Deep bass is emphasized.
: Deep bass is strongly emphasized.
: Normal sound
lights. If the unit remains in use after
D
a
b
D
D
E
C
Advertisement
Table of Contents
