Motorola Radius GM300 Operating Instructions page 2

CHANNEL SCAN
The 16-channel, GM300 mobile may have a preprogrammed scan list for each active channel
and a single user scan list which can be programmed from the front panel.
To turn scan on or off
Press the SCAN (
Green display segments will light to indicate that scan is functional. Use the SELECT (
to advance through the various scan types:
Scan
Pri
Usr
Scan
NOTE: The first and last displays apply to the preprogrammed scan lists and will be the only
types of scan available until a user list is programmed.
When an active channel is detected, the channel number will be displayed and you will hear the
call. To leave scan, press the SCAN (
To respond to scanned channel activity
When the microphone is lifted off-hook, the radio will suspend scanning and return to the chan-
nel displayed before entering scan. If you wish to transmit on another channel, press the
UP/DOWN ( /
microphone on-hook.
When scanning with priority, the green scan LED will flash to indicate activity on Priority One
and light steady for Priority Two.
To delete a nuisance channel
While receiving an undesired transmission, hold down the SELECT (
and the nuisance channel will be temporarily deleted (until scan is exited or the radio is turned
off). Priority channels and the home channel cannot be deleted.
To create or modify the user list
Hold the SCAN (
tone and the channel number flashes. The displayed channel can be
added or deleted from the user list by pressing the SELECT (
A vertical segment in the upper left corner of the display will light and
flash, alternating with the channel number to indicate that the flashing
channel has been added to the scan list. The segment will disappear when
the channel is deleted.
Use the UP/DOWN (
the user list.
To select priorities for the user list
Go to the desired channel and hold the SELECT (
will flash to indicate that this is the first priority channel. Repeat the process to select a second
priority channel. Priority Two will be indicated by a steady light on the scan LED.
The Priority-One channel must be programmed first, followed by the Priority-Two channel.
Deleting either of the priority channels will delete both channels simultaneously.
© 1997 by Motorola, Inc.
8000 West Sunrise Blvd.
Ft. Lauderdale, FL 33322
) button. The radio will only scan when the microphone is on-hook.
User Scan
) button to reach the desired channel. Scan will resume after replacing the
) button for two seconds until you hear a second chirp
/ ) and SELECT (
, Motorola, MaxTrac, PL, and DPL
are trademarks of Motorola, Inc.
Priority User Scan
Pri
Usr
Scan
) button.
+ ) buttons to add or delete other desired channels in
+ ) button down for two seconds. The scan LED
Pri
Usr
Scan
+
) button for two seconds
+ ) button.
+ ) button
Priority Scan
Pri
Usr
Scan
Pri
Usr
Scan
Printed in U.S.A.
All Rights Reserved.