9． Instructions On Inspection And Maintenance; 10． Troubleshooting - Nagano Keiki GS5 Instruction Manual

9. INSTRUCTIONS ON INSPECTION AND MAINTENANCE
The Metric Law specifies that certified instruments can not be repaired by any parties other
than the authorized manufacturers or repairers. Zero point adjustment falls under the
category of repair. Note that the pressure gauge can only be zero-adjusted by the
authorized manufacturer or repairer.
10. TROUBLESHOOTING
If some trouble occurs, see Table 10 Trouble shooting below and take the appropriate
countermeasures. If the trouble can not be eliminated by such countermeasures, contact
the dealer or our office.
16／18 Rev.2
TY1－3A