Care; Faulty Function / Reset; Storage And Disposal - DekoLight Quasar HVM Product Notes Manual

Product-Notes Manual

3. Care

Repairs may only be carried out by a qualified electrician.
Disconnect the entire product from the mains first and allow it to cool down before cleaning or maintaining.
Use a dry or slightly moistened cloth for cleaning.
Never use any chemicals, flammable cleaning agents or abrasives. These may cause damage to the surface
coating and/or the insulators.

4. Faulty Function / Reset

● Are the lights to be controlled ready for operation / correctly connected and supplied with power?
● Is the power supply guaranteed by the building installation?
● Can the connected lights / control gear be switched on / off by using button 1?
● In the event of general malfunctions, carry out a reset by disconnecting the controller from the mains for at
least 30 seconds.
For better function and error analysis, there are colored LEDs in the controller that give you information about
the operating status or any pending errors. The LEDs are visible when you look through the small opening on
the front of the housing.
LED-Colour Display Type Status-Information
Grün constantly
Blau constantly
Blau flashing
Rot constantly
Rot flashing

5. Storage and Disposal

Used electronic devices must be brought back to public collection points and must not be disposed of as
household waste.
Storage in a dry and clean environment. Do not strain the product mechanically during storage.
Deko-Light Elektronik-Vertriebs GmbH
www.deko-light.com / deko@deko-light.com
Technical Data can be changed without advance notice. Errors excepted.
supply voltage OK
BT-Network OK
no connection to other BT-components
supply voltage OK
BT-Network OK
connected to other BT-components
Fault,
system needs to be restarted
Module overheated
(check installation location and allow to cool)
Module overloaded
(reduce power and restart module)
Article No.: 843007
02.09.2020
4 / 24