Step 5: Start Recording; Re-Configure Your Logtags; Configuration Notes - LogTag Recorders TRIX-8 Quick Start Manual

Your LogTag is NOW ready.
TO START – Push and hold down the „start/mark‟ until the red
and green/ starting display indicators flash and then
release when they stop flashing.
Your recorder is now ACTIVE and will begin recording.

RE-CONFIGURE YOUR LOGTAGS

Repeat steps 2 to 6 each time you want to re-configure your LogTags
for use,
OR Quick re configure if settings are to remain the same.
Previous data will be cleared from the LogTag for re-use.
(Downloaded data will have automatically saved to: >documents>My
LogTag Data)
 Pre-start recorder is utilised if you would like the LogTag to start
taking readings BEFORE you press the start button (usually not
used- remove arrow )
 Frequency of readings will directly affect the duration of readings
the recorder can take, typically 8000.
 The temperature parameters you set only dictate when the alert
indicator will show and does not affect the recorders reading
capacity.
Tel: 021 852 7686
Step 5:

CONFIGURATION NOTES

Fax: 086 664 7173
43 Bright street, Somerset West, 7129
Email: info@logtagdata.com