SkyLink ATOMS ATR Series Instruction Manual page 20

PROGRAMMING GUIDE – LCD WALL CONSOLE
12. The LCD display will flash the number
"4".
13. Press the [ ] button again to close
the garage door. The flashing "4" will
change to solid.
14. The garage door opener will beep
once when door is fully closed and the
display will show "F".
Press [ ] button to confirm.
15. 
16. The LCD display will flash the remote
icon.
17.
Program a Remote:
Within 30 seconds, press any button
on the remote that you would like to
program to the opener.
Program a Wireless Keypad:
Please refer to page 43, part
" C. Keypad Initial Setup".
TM
(ATOMS+ ONLY)
PROGRAMMING GUIDE – LCD WALL CONSOLE
18. The garage door opener will beep if
remote is successfully programmed
and the flashing remote icon will
change to solid.
19. If you want to erase all the remotes,
press and hold the [] button for 5
secs until you see "E."
20. If you need to program additional
remote, press [] button, then refer to
step 18. After you've programmed all
remotes, press [ ] button.
21. The LCD display will show the time
setting.
22. Press the []/[] buttons to set
the hour to the current time; then,
press [ ] to confirm.
23. Press the []/[] buttons to set
the minute to the current time; then,
press [ ] to confirm.
24. The LCD display will show the remote
lock time setting.
25. Press the []/[] buttons to set
hour; then, press [SET] to confirm.
26. Press the []/[] buttons to set
minute; then, press [ ] to confirm.
27. The LCD display will show the remote
unlock time setting.
28. Press the []/[] buttons to set
the hour; then, press [ ] to confirm.
29. Press the []/[] buttons to
set the minute; then, press [ ] to
confirm.
30. On-ground programming is complete.
TM
(ATOMS+ ONLY)