SkyLink ATOMS ATR Series Instruction Manual page 16

INSTALL SAFETY BEAM SENSOR
5. Once the Wireless Safety Beam sensor is programmed, both
the green LED on the Radio Module and the blue LED on the
Wireless Safety Beam sensor will flash once. This is indicating
you have successfully programmed the Wireless Safety Beam
sensor to the Radio Module.
[SET] button
Wireless Safety Beam
Sensor (Master)
Install safety sensor shielding plate (optional) to the Wireless Safety Beam Sensor
If you have 2 garage doors and install 2 sets of garage door opener with Wireless
Safety Beam sensor, follow the instructions to add on the shielding plate to the Wireless
Safety Beam sensor to minimize the cross interference to the sensors.
1. Insert the shielding plate into the slot of the back case (1), and mounting bracket (2).

Shielding plate
Wireless Safety Beam
Sensor with bracket
[SET] button
Radio Module
Installed the
Shielding plate

INSTALL SAFETY BEAM SENSOR
2. Mount the shielded Wireless Safety Beam sensor back to back on the door tracks.
3. Align each pair of the Wireless Safety Beam sensors, refer to the instructions in page 29.
31 31 32