Troubleshooting - Hitachi R-WB640VRU0 Instruction Manual

No frost
Hide thumbs Also See for R-WB640VRU0:
Table of Contents

Advertisement

Troubleshooting

Before you call for service, please check the following items:
Problem
The refrigerator does not get cold
at all.
The refrigerator does not get cold
enough.
Food in the refrigerator
compartment freezes.
Dew appears Outside
Dew appears Inside
The inside is smelling.
The refrigerator is noisy
The Control Panel does not respond:
Problem
The Control Panel
does not respond:
The Control Panel is unlit.
The Control Panel display keeps
changing
This is not a malfunction of the refrigerator:
Problem
The surface of the refrigerator
is hot.
If a door is shut, other doors
may open.
Does the refrigerator make any
abnormal noises (sound)?
There are waving and / or
distortions on the door surface,
the side and the top surface of
the refrigerator.
Things to check
● Is the refrigerator plugged in properly?
● Is the refrigerator placed in the direct sunlight?
● Is the temperature set to "Cold"?
● Is the food stored too much?
● Is the door slightly opened?
● Is the refrigerator placed near heat sources?
● Has anything hot been placed in the refrigerator?
● Is the door opened and closed too frequently?
● Is the temperature set to "Coldest"?
● Do you place food with moisture or vegetables
nearby the cold air vent? It will be frozen if it is
is placed nearby the cold air vent.
● When the ambient humidity is too high, the door
gasket may have dew. Please wipe it up with dry cloth.
Please wipe it off with dry cloth and please
check the details below.
● Is the door closed firmly?
● Is the door opened and closed too frequently
or opened for a long time?
● Is it too humid outside?
● Do you store food with odor without warpping it?
● Make sure the refrigerator is installed frimly.
Is the refrigerator touching the wall?
Things to check
● Is "Child Lock" function activated?
● Is Refrigerator the compartment Door open?
Operate after closing it.
● Is there water or dirt on the Control Panel?
● Are you wearing gloves or applying a plaster?
Touch directly with your finger.
● Are you touching a next button?
Touch only one button at a time.
● Approximately 30 seconds after the end of
operation, Indicator LEDs become unlit.
-
Things to check
-
-
-
-
Instructions
●Check the fuse box for blown fuse
or tripped circuit breaker.
● Do not install the refrigerator in a place where it
may come in contact with sunlight.
● Touch " Refrigerator " button to normal or coldest.
● Keep enough space between food.
● Should close the door firmly closed.
● Do not install the refrigerator in a place where it
may come in contact with heat sources.
● Make food cool enough before putting in the refrigerator
● Do not open & close the door too frequently.
● Touch "Refrigerator" button to narmal or cold.
● Keep enough space between food,Do not block the
cold air vent.
● See content " Dew or frost is generated" .
● See content " Dew or frost is generated" .
● Using food wrap or sealed containers.
● Should be install the refrigerator by following the
preparing instruction manual.
Instructions
● See content "How to use the control panel"
● See content "How to use the control panel"
● This indicates that the refrigerator is running is
store-display mode.
● The refrigerator will not cool while running in
store-display mode.
● Turn off the store-display mode by
1) Power off and Power on the refrigerator again.
2) After that the refrigerator will return to normal
mode.
Instructions
● The refrigerator is equipped with the dew prevention
and heat radiation tubes.
The back and side plates may be heated especially
when starting up or if the door is frequently opened
and closed.
● The two compartments are connected with an air duct.
When closing one of the doors, the other door may be
opened by the air pressure through the duct.
This is a normal phenomenon.
● The sound like water flowing and boiling water is the
sound of the cooling liquid (refrigerant).
● A creaking sound comes from the storage
compartment. It is the sound caused b y friction of
the parts due to temperature change.
● Slight waving and/or distortions are generated in the
manufacturing process of the refrigerator.
They may be conspicuous according to the position of the
light source and/or the brightness etc.,
but there is no problem with the performance.
Page
2
4
5
4
-
4
4
-
5
4
15
15
4
4
Page
5-7
5-7
-
Page
-
-
-
-
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents