Magnetic Track Selections (Only For Security Level 1 & 2) - IDTECH SecureHead User Manual

<Len> = the number of bytes of prefix string
<Prefix> = {string length}{string}
NOTE: String length is one byte, maximum six.
4.1.9. Track n Suffix Setting
Characters can be added to the end of track data. These can be special characters to identify the
specific track to the receiving host, or any other character string. Up to six ASCII characters can be
defined.
<STX><S><n><Len><Suffix><ETX><CheckSum>
Where:
<n> = 37h for track 1; 38h for track 2 and 39h for track 3
<Len> = the number of bytes of suffix string
<Suffix> = {string length}{string}
NOTE: String length is one byte, maximum six.
4.8. Magnetic Track Selections (Only for Security Level 1 & 2)
4.1.10. Track Selection
There are up to three tracks of encoded data on a magnetic stripe.
This option selects the tracks that will be read and decoded.
<STX><S><13h><01h><Track_Selection Settings><ETX><CheckSum>
Track_Selection Settings:
"0" Any Track
"1" Require Track 1 Only
"2" Require Track 2 Only
"3" Require Track 1 & Track 2
"4" Require Track 3 Only
"5" Require Track 1 & Track 3
"6" Require Track 2 & Track 3
"7" Require All Three Tracks
"8" Any Track 1 & 2
"9" Any Track 2 & 3
Note: If any of the required multiple tracks fail to read for any reason, no data for any track will be
sent.
Copyright © 2010-2013, International Technologies & Systems Corporation. All rights reserved.
SecureHead SPI Interface with FPC User Manual
Page 19 of 67