Advertisement
Tetra
Power Supply GEPS12-25U-EU
®
RISK OF ELECTRIC SHOCK
• Disconnect power at fuse box or circuit breaker before servicing or
installing product.
• Properly ground Tetra
power supply.
®
RISK OF FIRE
• Use only approved wire for input/output connection. Minimum size
18 AWG (0.82 mm
).
2
• Follow all local codes.
• Application considerations potentially requiring additional spacing
include high ambient temperature seen by the power supply, poor
contact with a heat dissipating material, inadequate ventilation, or
direct exposure to sun.
RISK OF INJURY
• While performing installations described, gloves, safety glasses or
goggles should be worn.
Power Supply Installation
Mount the power supply. Mounting
1
the power supply base directly to
a thermally conductive installation
surface can improve thermal
performance.
NOTE: All electrical connections
should be suitably protected
from mechanical damage and the
environment. Seal all connections
exposed to water with electrical
grade self-hardening silicone.
OPTIONAL
A Weather Box (GEXNWB2) may be used to
house and seal Class 2 connections.
A) Insert wire connectors into weather box. Fill
with electrical grade silicone and close box.
B) Secure the weather box using a #6 or #8
(M2 or M3) screw.
WARNING / AVERTISSEMENT
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l'alimentation électrique à la boîte de fusibles ou au disjoncteur
avant l'entretien ou l'installation du produit.
• Assurez-vous de correctement mettre à terre le bloc d'alimentation Tetra
RISQUES D'INCENDIE
• N'utilisez que des fils approuvés pour les entrées/sorties de connexion.
Taille minimum 18 AWG (0.82 mm
• Respectez tous les codes locaux.
• Certaines applications pourraient requérir un espacement additionnel,
p. ex. une température ambiante élevée autour du bloc d'alimentation,
un mauvais contact avec une matière dissipatrice de chaleur, une
ventilation inadéquate ou une exposition directe au soleil.
CAUTION / ATTENTION
RISQUES DE BLESSURE
• Lors de l'exécution des installations décrites, des gants, des lunettes de
sécurité ou des lunettes de protection doivent être portées.
Input
Black or brown
wires
White or blue
(neutral)
AC line
Connect the AC line to the black
2
or brown (line) and white or
blue (neutral) input wires of the
power supply using suitable wire
connectors.
WARNING
RISK OF ELECTRIC SHOCK
AC input connections shall be
suitably enclosed.
A
2
Installation Guide
).
2
Red (+)
(line)
Output
wires
Connect the supply wire that is
3
attached to the Tetra LED System
to the red (+) and black or blue (-)
output wires of the power supply
as outlined in the "Electrical
Connections" section of your LED
system's Installation Instructions.
NOTE: To avoid overloading this
power supply with LED modules,
please refer to the specific module
loading guides.
B
.
®
To Tetra LED System
Black or blue (-)
Weather box
can be painted
Light engine
Advertisement
